Fermion: MEMS Carbon Monoxide CO Gas Detection Sensor
4.50 د.ك
The sensor can measure carbon monoxide gas concentrations qualitatively and is suitable for carbon monoxide leak alarms and portable carbon monoxide detectors.
In stock
Description
Precautions for use
- Kindly remove the protective film before usage.
- To prevent exposure to volatile silicon compounds vapors (such as silicone adhesive, hair gel, silicone rubber, or other locations where volatile silicon compounds are present).
- Avoid exposure to high concentrations of corrosive gases (such as H2S, SOX, Cl2, HCl, etc.).
- Prevent contamination from alkalis, alkali metal salts, and halogens.
- Refrain from prolonged exposure to extreme environments (such as high temperatures, high humidity, high pollution).
- Avoid contact with water, condensation, and freezing.
- Minimize excessive vibration, impact, and dropping.
- Please refrain from employing this module in systems that involve personal safety concerns.
- For extended periods of non-usage, it is advisable to preheat the module for at least 24 hours.
Features
- Compact size, measuring only 13*13*2.5mm
- Low power consumption
- High sensitivity and rapid response recovery
- Advanced MEMS technology
Applications
- Petrochemical carbon monoxide detection
- Metallurgy carbon monoxide detection
- Mining carbon monoxide detection
- Environmental protection
Specification
- Gas detected: CO
- Detection range: 5-5000ppm
- Operating voltage: 3.3-5V
- Operating current: <20 mA
- Output signal: Analog voltage
- Sensitivity: R0(in air)/Rs(in 150ppm CO) ≥ 3
- Operating temperature: -10-50℃
- Operating humidity: 15-90%RH (non-condensing)
- Lifespan: ≥5 years (in air)
- Dimension:13×13 x 2.5mm/0.0.51×0.51×0.1″
Documents
Shipping List
- Fermion: MEMS Carbon Monoxide CO Sensor (breakout) × 1
- 2.54mm pitch header pin × 1